Chandler

Is it still possible to obtain the original MK2 Lynx LCD screen? maybe Best electronics? I know there are LCD replacement screens out there but i was looking for an original part

Well i've been trying to make this TOS 4.04 Eprom with no success, i'm using Hitachi erasable HN27C4096CC-12 EPROMs Using a Willem PCB50 programmer I load the file (512K) (Downloaded from this thread) into the Willen PCB50 I can see the first word starts 602e The EPROM is blank, the programmer copies and verifies the image I insert the EPROM into the Falcon and all i get on a low res colour monitor is a black screen with red lines, no boot Re install the original rom and all is well so there's nothing up with the Falcon Can anyone help?

OK So i see from these files that there are 2 x U44 files (U44.LCR and U44.JED) So which file do i use? and how do i get them onto the IC? obviously i have an eprom programmer I just want to make sure i program the chip correctly as don't want to damage the Falcon!

Yes i know i could make something but ultimately i'd like the original part :0)

I'm after one of the small blocks used to mount the Serial port on the rear of the Mega STE / TT (see pic) If anyone can help let me know thanks

Can i use HN27C4096CC-10 or does the rom need to be a -12 or -15 ? Thanks

Thanks So do i need to do anything to this image or can i simply burn that file onto a rom?

Can anyone point me in the right direction of a working Falcon TOS 4.04 rom image please so i can burn my own TOS rom Thanks

OK so i used a phone camera to check the LEDs on an STM1 i have that doesn't move left/right And sure enough i can see all 4 LEDS emitting a purple coloured light So does this mean the LEDS are ok? and there is something else causing the lack of left/right movement? On this particular mouse i have changed the cable and caps and still the issue, no broken solders or tracks What else to look at apart from changing the chip and testing resistors?!

Thanks for this Is it also possible to save the data on a working Gal/Pal into the rom burner and then burn back the data to a new chip?

These chips - U62, U63, U67, U68 Chips C30283(0/1/2/3)-001 PAl/GAL/IC And the longer U44 chip

Does anyone know where i could find the gal / pal images for the 5 small chips on the Falcon?

How do you use a cell phone to test the wheel emitter?

I have a logic probe. Ok so i will check as you say around A3 area... Thanks for your help

I'm just going on what is stated in the Falcon service manual for testing CPU, "check data and address lines to see if they are toggling" it says when test cartridge fitted on initial power up The manual doesn't specify which data and address lines to check so do i assume any of them??!!