Gandor

I measured the width and it is just over 144 mm, I don't have anything to measure the length in mm (my calipers don't reach that far). I also printed the model that Foft published but it is very fragile compared to this one. I already broke off some of the sides from that one. Foft's model is just over 136 mm wide. I have to remove the 2 post because otherwise the board wobbled. Maybe there are some soldering joints underneath that made contact? I tried most ports: - The joystick ports and sio are perfectly centered and I have no issue populating them. - Power plug fits, not sure if it will with the top cover on (printing the top right now and it will not be done until sometime tomorrow afternoon) - Power switch seems fine. - VGA fits fine (didn't try audio jack). - USB ports are an issue, plugs don't fit in far enough. - HDMI port is also an issue, plug doesn't fit in far enough. - SD card fits just fine and when inserted is flush with the side. The unit is very sturdy (especially compared to the Folf's model). Feels just like a real Atari case . I'll see if I can post some detailed pictures.

Switched to silver color filament and now it will be (hopefully) another 20 hours before the top part is done.

Sent from my iPhone using Tapatalk

And one more picture with the board attached to the case with some m3 * 12. The holes line up perfectly. Mounted it from the bottom up. Sent from my iPhone using Tapatalk

case with 2 supports removed and sio connector trimmed Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

I only printed the bottom piece but man does it look nice. Outside holes line up nicely [emoji106]. Had to trim some of the edge of the sio because it was sticking past the motherboard and remove the 2 inner supports but now it fits perfectly. I printed it in blue (that is what I had on it) but going to switch to grey and print the top part. Sent from my iPhone using Tapatalk

PM sent

I like tinkercad, very easy to use. Never use a 3D printing service because an Ender 3 can be bought for less than $200.-

Looks awesome and wouldn't mind the stl files. It would be nice to print a case for mine.

Just updated mine

Interested in one cart

Looking great and reminded me to order all three .

WOW super nice intro Sent from my iPhone using Tapatalk

Finally the website was available again and I could place my order. Sent from my iPhone using Tapatalk

Yes, this was exactly what I meant. This interface board with the 4 switches would contain the connector to hook the XEGS keyboard up to. This would be similar to the MiSTer case where the I/O expansion board has 3 micro switches and the case has 3 buttons which would push those switches (see https://www.thingiverse.com/thing:2684660)

Could these keys be added to the interface board where the XEGS keyboard connects too?

Thanks, that worked

Received my mini eclaireXL today and I must say wow. Just love the small form factor. Got to find some time to make a case for it.

Anybody know where I can download the software, tmp's website doesn't seem to work (get blank page).

I am interested in one [emoji106] Sent from my iPhone using Tapatalk