[Another World Jaguar Pre-Order]

Albert or whoever is keeping track of the US order, I'd be interested in two, one for myself and one for my son, thanks!

 

Chris

[Upcoming Jaguar Game Drive Cartridge]

I just placed my order! Yay!!! Can't wait until I have it!

[Any sources for Jaguar overlays?]

Thanks! I like to repair, restore these old consoles, the only Atari I have not done is the 5200! The Jaguar is a cool system! Rick Dangerous is a client of mine and I’ve done a lot of work for him. And I appreciate the business.

[Need switch for Sears Video Arcade II (2800)]

Greetings all,

Found some at Best Electronics, I highly recommend them!

Chris L.

[Any sources for Jaguar overlays?]

Greetings,

Does anyone know of any sources for Atari Jaguar overlays? I am in need of one for DOOM and one for Hover Strike. Appreciate any help locating them.

Thanks,
Chris L.

[Need switch for Sears Video Arcade II (2800)]

Greetings,

I am looking to find a source for a reset switch for an Atari 2800, anyone know where I could get one? Any help is appreciated, the console works, but cannot play a game due to the reset switch. Thanks!

 

Chris

[Just got a Jag, Powers On, No Video or Audio]

I just picked up a Jaguar that was listed as, may not work, can't test , etc from EBay. Unit powers up, but no audio or video output, cleaned the connector for the cartridge, verified power supply, cable RF and AV composite cable, nothing, All of hte cables, and cartridges work in my other Jaguar. Any ideas?

[Jaguar Game Audio Quiet, System New With Perfect Capacitors, Reflow REG1?]

To verify REG1, with a cart in the system, power it on and measure pin 8 of REG1 to make sure the voltage is getting through the power switch, then measure pin 1, which should read approx +5 volts. I use the ground for the negative probe on my DVM, which are the silver strips along the edge of the board, there are two of them on the edge by the joy stick connectors. I hope that helps.

[different versions, different schematics?]

Good morning all,

I recently picked up a Jaguar, which has C134, U38 and REG1 blown. No problem, I have replaced these before and I have added a full wave bridge rectifier and capacitor before CH1 on several Jaguar systems to alleviate this problem of the wrong polarity 9V supply being used.. This particular Jag has a blue wire from pin 1 on U11 to TP3, the full schematic I have does not show this connection. The board has a Rev J on the bar code label attached to the board.

My personal Jag has this connection with no wires, and the bar code label says Rev R2.

My question is does anyone have a different schematic than the one I am using, which shows this change on the board?

Thanks!

 

Chris L. - in Vermont

[Upcoming Jaguar Game Drive Cartridge]

I certainly want to get on the preorder list, when it is available, but last I knew, it did not exist

[Upcoming Jaguar Game Drive Cartridge]

Awesome job Sain T!! Can't wait until this is available for purchase!!

[Upcoming Jaguar Game Drive Cartridge]

I am very new to the Jaguar console and am also very excited about the SD card Jaguar cartridge! Can't wait until we can get on a pre order list! Great work sir!