Shawn Posted July 26, 2018 Share Posted July 26, 2018 A success story using low_budget's v2.0 schematic in this thread to make my own board: atari_5200_videomod.JPG I used a couple of GTIA footprints on the board to allow a plug-and-play installation by piggybacking the GTIA onto the board and then plugging the whole assembly in. Only using composite at this time. Audtio out is via a capacitor soldered to the usual location. PM sent. Quote Link to comment Share on other sites More sharing options...
smbaker Posted July 30, 2018 Share Posted July 30, 2018 Seems my board isn't working quite as well as I thought, noticed some ghosting today: Not sure whether this is my board layout, my console, my monitor, or some dubious resistor substitutions I had to do (should have all the right resistors in a week or two). Quote Link to comment Share on other sites More sharing options...
Shawn Posted August 12, 2018 Share Posted August 12, 2018 So how much does the UAV mod cost again? After looking at the cost to source the parts for this cheaper mod it's looking like $25 which isn't exactly much cheaper Quote Link to comment Share on other sites More sharing options...
jjh76 Posted August 12, 2018 Share Posted August 12, 2018 $22 or $25 depending on if you want pin headers and a terminal strip, here's the thread for the latest version: http://atariage.com/forums/topic/260267-the-uav-rev-d-video-upgrade-thread/ 1 Quote Link to comment Share on other sites More sharing options...
Shawn Posted August 12, 2018 Share Posted August 12, 2018 $22 or $25 depending on if you want pin headers and a terminal strip, here's the thread for the latest version: http://atariage.com/forums/topic/260267-the-uav-rev-d-video-upgrade-thread/ I just messaged him to buy one. Thanks for your help. Do you know of any other currently available options as well? Quote Link to comment Share on other sites More sharing options...
jjh76 Posted August 13, 2018 Share Posted August 13, 2018 There are a few other options scattered in various threads on the board, but I don't know much about them because I stopped looking after I found out about the UAV 1 Quote Link to comment Share on other sites More sharing options...
xefned Posted September 4, 2019 Share Posted September 4, 2019 On 8/12/2018 at 7:44 PM, Shawn said: Do you know of any other currently available options as well? There's also this s-video project on a breadboard from David Nelson if you're planning to mod all your 5200's with different methods to compare them. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.