Check your TV's manual. If there is a menu that allows you to force RGB mode on the SCART input, then it's easy: just cut the wire going to pin #16 inside the SCART connector, and use the menu to enable RGB mode.   If not, a bit more work is required : - get a 150 ohm, 5 % tolerance, 1/4 or 1/2 W resistor (you can buy one in any shop that sells electronic parts) - take apart the SCART connector - cut the wire going to pin #16 - unsolder the wire going to pin #8, and solder it to one side o
    • Like
    1