EAGLE component needed

[Shift838]

Does any of our community hardware developers have a Eagle PCB component already made for the male end of the cartridge board (both sides) I can use? If not I will have to make one.

 

 

[brain]

http://www.go4retro.com/downloads/EAGLE_libs/ti994a.lbr

 

Jim

Edited January 2, 2018 by brain

[Shift838]

thank you! I'll check this out next day or so.

 

I want to make a PCB version of my home-made 2 port cartridge widget I am using in my Franken-TI (all in one 99/4a and PEB).

[Shift838]

i'm also looking for the 8 pin DIN female connector eagle component that I can use for a Geneve video port.

[Sinphaltimus]

thank you! I'll check this out next day or so.

 

I want to make a PCB version of my home-made 2 port cartridge widget I am using in my Franken-TI (all in one 99/4a and PEB).

 

 

I'd love to use that to expand it into an 4-port version if you don't mind. Although I don't have or use EAGLE, I think there is a free version available legit for simple electronics use.

[Shift838]

 

 

I'd love to use that to expand it into an 4-port version if you don't mind. Although I don't have or use EAGLE, I think there is a free version available legit for simple electronics use.

 

I just started using eagle. Once you get it down it's fairly simple. I like it.

 

There is a free version which is good for small boards. I ordered my first board this past Friday to see. a fairly simple design (non TI related) for my MIDI-USB Foot Controller to control my recording software via foot switches. All uses open source hardware...