zoggins Posted October 10, 2019 Share Posted October 10, 2019 I have a heavy sixer that the second paddle on the 1st controller port is no longer working. It was working 1 second and not the next. The paddle works fine on another 2600. I am assuming someting is wrong with one of that controller port's pot lines, but I have no idea even where to start looking for the problem. Any help would be greatly appreciated. Quote Link to comment Share on other sites More sharing options...
+Mitch Posted October 10, 2019 Share Posted October 10, 2019 I would guess that it is either a bent pin or a cracked solder joint on that port. It could be something in the electically circuit but I would start by checking the port. Mitch Quote Link to comment Share on other sites More sharing options...
+Nezgar Posted October 29, 2019 Share Posted October 29, 2019 Could also be a bad 6532 aka RIOT chip. Try reseating and/or replacing it. PA1 (the 2nd paddle) is Pin 9 on the RIOT if you want to check continuity. Quote Link to comment Share on other sites More sharing options...
zoggins Posted May 7, 2022 Author Share Posted May 7, 2022 (edited) N/a Edited May 7, 2022 by zoggins Wrong thead Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.