#FujiNet v1.6 Hardware
#FujiNet v1.6 hardware design files are now available on Github. The changes are listed in the README and on the Wiki. The biggest changes are the new SIO receptacle pins which are thicker and longer, providing a better fit for SIO cables and the new optional external antenna.
Attaching the new receptacle pins to the board is a ...process... For the older versions I was using the 3D printed receptacle to hold the pins during soldering. This method does not work so well with the new p
Here is the WROVER module with added smd U.FL connector and correct resistor placement for external antenna. The R14 spot is for external antenna and the R15 spot is for internal pcb antenna. If you are unable to move the 0201 resistor (or if you loose it ) you can replace it with a solder blob on the necessary pads.
This is the RP-SMA pigtail installed in the new XL style antenna case back. A short coaxial cable is best. There are some 4 inch ones readily available that work w
