Jump to content

Short to ground after recap.


Recommended Posts

So I have a console that had a sound but no picture fault when I bought it.  Voltages at the logic board connector were low, so I decided to recap the power board.  After recap, the .5 amp fuze blew.  Stupidly, I had not checked the caps before attempting to restart- about half showed as shorted to ground.  I have removed the caps and still have the shorts.  I've looked over the board and can't see any obvious solder blobs. Any ideas on where to look?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...