4-switch Power LED mod (no drilling required)
Here's a quick power LED mod I did for my 4-switch woody 2600. It's not pretty but it works so far. I didn't want to mess with the original look of my Atari, so I chose not to drill a hole at the top or through the power switch itself.
I used a 150 Ohm resistor and used the 5V and Ground on the main board. I didn't want to solder directly to pins 2 and 3 of the voltage regulator but I could have done that instead. The short pin on the LED goes to Ground.
I also made sure the wires did
Here's a quick power LED mod I did for my 4-switch woody 2600. It's not pretty but it works so far. I didn't want to mess with the original look of my Atari, so I chose not to drill a hole at the top or through the power switch itself.
I used a 150 Ohm resistor and used the 5V and Ground on the main board. I didn't want to solder directly to pins 2 and 3 of the voltage regulator but I could have done that instead. The short pin on the LED goes to Ground.
I also made sure the wires did
