SDrive-MAX Question

Sorry to start a new thread, but this doesn't seem to fit on the other SDrive threads. I have built a couple of SDrives. If I apply power, they seem to work (0.9 firmware): Screens look correct, I can plug them into an A8 (XEGS) and they start to boot, but then hang. I think the crux of the issue is that at startup, the SDrive cannot seem to find SDRIVE.ATR even though it is on the uSD AND, if I try to load it in D1: the SDrive sees it and will put it at D1. Any thoughts? Thanks for

Hi @MacRorie, These files reset the Arduino correctly, but I had made a mistake soldering the SIO wires to the Arduino, but once this was fixed, the SDrive Max worked correctly. On Linux (Ubuntu), I reset the Arduino with: $ sudo avrdude -c usbasp -pm328p -P usb -U flash:w:eeprom_clear.ino.with_bootloader.standard.hex avrdude: warning: cannot set sck period. please check for usbasp firmware update. avrdude: AVR device initialized and ready to accept instructions Rea