Adapter series to extract RF from Studio 2 power cable
Studio 2 terminates in a male RCA phono connector carrying both DC power and RF signal from the unit. To adapt to an old NTSC type TV, use the following chain:
RCA phono-Female to BNC-female
BNC-Male to F-female
F-female to f-male DC block
F male to F-male RF cable to TV RF input (antenna)
(Note: Only works with legacy TV tuners.)
Solder or otherwise connect a DC source to the voltage regulator and this will allow the unit to be used in the event a switch box is not available or does not work.
Photo Information
- Taken with Panasonic DMC-TZ1
- Focal Length 5.2 mm
- Exposure Time 10/150
- f Aperture f/2.8
- ISO Speed 400
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.