deffroe Posted February 11, 2023 Share Posted February 11, 2023 Hi all. Today I installed a Deluxe Compsite mod from TheFutrewas8bit. The porcess went as expected and there is a massive improvement over RF but I'm having a little issue. The graphics have a shimmering type effect where they are rapidly changing from solid colours to a more chequerboad effect. Any clues to what might be causing it? I'll upload a couple of photos to show the effect. Thanks Phil Quote Link to comment Share on other sites More sharing options...
deffroe Posted February 11, 2023 Author Share Posted February 11, 2023 You can see on the speed bar and gear select in Pole Position. The effect is a rapid shimmering/twinkling effect. Quote Link to comment Share on other sites More sharing options...
Ouzy Posted February 11, 2023 Share Posted February 11, 2023 (edited) Was it the same motherboard shown in Tfw8b photo and did you cut the yellow cable down to size. Also make sure that when you soldered it, it never touched any other resistors. I never removed the RF board rather cut components that were no longer required and left them in situ. Where did you ground it too? I did mine last week see photo.. Worked fine. Edited February 11, 2023 by Ouzy Added photo of pole position Quote Link to comment Share on other sites More sharing options...
deffroe Posted February 11, 2023 Author Share Posted February 11, 2023 I knew there was some photos missing... I could shorten the cables I little more and I positioned the jack socket in the same location as the RF connected. Quote Link to comment Share on other sites More sharing options...
Ouzy Posted February 11, 2023 Share Posted February 11, 2023 Your composite connection seems to be in the correct place. Is anything touching where u have hot glued the jack socket? Might be worth checking that. It's the same mod I have done but mine is a lazy way, but works just the same. Quote Link to comment Share on other sites More sharing options...
Ouzy Posted February 11, 2023 Share Posted February 11, 2023 If its not the above then you may have to wait for someone more expert with PAL boards. But I did have jaggies when I first put the case back on and had to relocate my jack as it was touching somewhere. Quote Link to comment Share on other sites More sharing options...
deffroe Posted February 12, 2023 Author Share Posted February 12, 2023 Only extra thing I did was extend the resister at I think R8 so the socket would sit flat to the board. Is it possible for that to cause the flicker Quote Link to comment Share on other sites More sharing options...
deffroe Posted February 12, 2023 Author Share Posted February 12, 2023 Found the issue with the shimmering/flicker display...Tried the console on two Samsung TV's, one a 4K the other an older 1080p and there was no issues with the displayed image, back to my LG TV/Monitor and shimmer shimmer. Need to now re-evaluate some video mods on my other Atari 8bits. Regards Phil 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.