+grips03 Posted July 30, 2012 Share Posted July 30, 2012 I'm building a home made Colecovision controller. Base is Dreamcast arcade stick, with Seimitsu LS-32, and 30mm screw in buttons. I'm looking to have a control panel overlay printed, but need artwork. Control panel is 11 1/4 wide by 6 5/8 tall. Or 28.5 cm wide and 16 cm tall. I was thinking of putting Colecovision logo on bottom left say 1 inch in from side and 3/4 inch from bottom. Logo should be about 1 inch tall. Top part of can have silver lines or whatever would make this look Coleco'ish, but can't have logo due to joystick, keypad, and button cutouts. Most of control panel will be black. I'm still up in the air about dyeing off white controller base black. thanks 1 Quote Link to comment Share on other sites More sharing options...
playazclub Posted August 9, 2012 Share Posted August 9, 2012 I'm building a home made Colecovision controller. Base is Dreamcast arcade stick, with Seimitsu LS-32, and 30mm screw in buttons. I'm looking to have a control panel overlay printed, but need artwork. Control panel is 11 1/4 wide by 6 5/8 tall. Or 28.5 cm wide and 16 cm tall. I was thinking of putting Colecovision logo on bottom left say 1 inch in from side and 3/4 inch from bottom. Logo should be about 1 inch tall. Top part of can have silver lines or whatever would make this look Coleco'ish, but can't have logo due to joystick, keypad, and button cutouts. Most of control panel will be black. I'm still up in the air about dyeing off white controller base black. thanks I really hope its not the rare arcade stick for the dreamcast. That's worth some $$$ Quote Link to comment Share on other sites More sharing options...
+evg2000 Posted August 10, 2012 Share Posted August 10, 2012 I'm building a home made Colecovision controller. Base is Dreamcast arcade stick, with Seimitsu LS-32, and 30mm screw in buttons. I'm looking to have a control panel overlay printed, but need artwork. Control panel is 11 1/4 wide by 6 5/8 tall. Or 28.5 cm wide and 16 cm tall. I was thinking of putting Colecovision logo on bottom left say 1 inch in from side and 3/4 inch from bottom. Logo should be about 1 inch tall. Top part of can have silver lines or whatever would make this look Coleco'ish, but can't have logo due to joystick, keypad, and button cutouts. Most of control panel will be black. I'm still up in the air about dyeing off white controller base black. thanks I really hope its not the rare arcade stick for the dreamcast. That's worth some $$$ these are worth some $$$? I've got one on my shelf in the box: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.