Jfcatari Posted January 5 Share Posted January 5 (edited) Question on Pot trimmer for Atari NUC I can't get this anymore https://www.digikey.com/en/products/detail/bourns-inc/3319p-1-504/2536263 But would these work? https://www.digikey.com/en/products/detail/amphenol-piher-sensing-systems/PT10MV10-504A1010-S/9555913 or this https://www.digikey.com/en/products/detail/tt-electronics-bi/37PR500KLF/7718733 Edited January 5 by Jfcatari Quote Link to comment Share on other sites More sharing options...
AtariGeezer Posted January 6 Share Posted January 6 (edited) Appears ok... Edited January 6 by AtariGeezer Quote Link to comment Share on other sites More sharing options...
Jfcatari Posted January 6 Share Posted January 6 Thanks for the help. I still working on collecting the part for the Atari NUC build. Quote Link to comment Share on other sites More sharing options...
Jfcatari Posted January 8 Share Posted January 8 I am looking to start a NUC build but I had some questions before starting: I see there are IC's/resistors/caps under the CPU, Antic and GTIA. Are the sockets required for the CPU ANTIC, and GITA deep enough to allow the component under them to be installed? Are special deeper sockets being used? Quote Link to comment Share on other sites More sharing options...
Jfcatari Posted January 8 Share Posted January 8 Ahh..I think I have the answer. The BOM calls for 7 40pin sockets... I guess we double stack to get the clearance for the CPU and GITA. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.